Amkette iGrip MagSafe

iGrip MagSafe Wireless ChargerMagSafe Alignment RingCentering Scale + StickersType-C to Type-C CableQuick Start Guide

No, a PD (Power Delivery) car charger is not included. We recommend using a 20W or higher PD car charger for optimal performance.

Unscrew the nut from the ball joint.Insert the ball head into the socket and tighten the nut.Rotate the rear dial to extend the vent clamp.Place it into your car’s air vent and tighten to secure.Plug in the Type-C cable and connect to a PD car charger.

Clean the back of your phone or case.Use the centering scale to place the ring accurately.Remove adhesive backing and stick the ring into place.Press gently to secure.

Yes, if you are using a MagSafe compatible smartphone without a case, or with a MagSafe-compatible case, you can skip this step.

Yes. The mount features a full 360° ball joint that allows you to adjust the viewing angle as per your preference.Press FN + 1/2/3 to toggle the connection mode.

The wireless charging feature has an efficiency of over 80%, providing fast and reliable charging within a range of 3-6 mm.

Use a 20W or higher PD (Power Delivery) car charger for best performance. Lower wattage chargers may result in slower or inconsistent charging.

The iGrip supports up to 15W wireless charging for compatible devices.

Any smartphone (Android or iOS) supporting wireless charging.

Yes, using the included MagSafe Ring, any Android phone with wireless charging support can be used.

Yes. For best magnetic alignment and charging efficiency, use a MagSafe-compatible case.

Ensure the charger is plugged into a 20W or higher PD car charger.Check if your phone supports wireless charging.Verify correct alignment of the MagSafe Ring (if using one).Make sure there are no metal objects between the phone and the charger.

Check if you’re using a non-MagSafe case or a thick case.Ensure the MagSafe ring is aligned properly using the centering scale.