boAt Rockerz Apex – Complete Support Guide with Specifications & FAQs

📄 Original Source: boAt Official Support – Rockerz Apex

boAt Rockerz Apex

In-Ear Earphones with DIRAC Spatial Bionic Sound & BEAST™ Mode

Sound That Takes You Beyond

Experience the sound that takes you beyond with Rockerz Apex. With Spatial Bionic Sound powered by DIRAC, indulge in an immersive listening experience like never before, with super low latency and crystal-clear calls:

12mm Dynamic Driver – Powerful, immersive sound
Spatial Bionic Sound – Powered by DIRAC, on by default
BEAST™ Mode – Super low latency for gaming
ENx™ Technology – Crystal-clear calls
IPX4 Water Resistant – Built for durability
aptX & cVc Support – Higher-quality audio and clearer calls
Bluetooth 5.3 – Stable 10m connection

Key Features at a Glance

🎧 Spatial Bionic Sound

DIRAC-powered immersive audio, on by default

⏱️ 30 Hours Playtime

220mAh battery, ~50 min charge time

🎮 BEAST™ Mode

Toggle low latency via long-press MFB

👆 Touch Sensor Controls

Swipe for volume, double-tap for tracks

Full Specifications

Specification	Details
Type	In-Ear Bluetooth Earphones
Bluetooth Version	V5.3
IPX Rating	IPX4
Driver Size	12mm × 2
Frequency Response	20Hz – 20kHz
Battery Capacity	220mAh
Music Playtime	Up to 30 Hours
Charging Time	About 50 Minutes
Charging Interface	USB Type-C
Transmission Range	10 Meters
Compatibility	All Bluetooth Devices
BEAST™ Mode	Yes
aptX Codec	Yes (requires aptX-supported source device)
cVc Technology	Yes

📄 Official User Manual

An official user manual image guide is available from boAt. See the original support page for the full visual manual.

Technology & Features

Spatial Bionic Sound (DIRAC)

Spatial sound is on by default. Double tap the touch ring to switch to boAt Signature Sound instead. A long tone confirms Spatial Sound is on; a short tone confirms boAt Signature Sound is on (Spatial Sound off).

BEAST™ Mode (Low Latency)

Long press the MFB for 3 seconds to activate or deactivate low-latency BEAST Mode – suitable for entertainment and casual gaming, though not intended for professional gaming equipment needs.

aptX Codec Support

Rockerz Apex supports the aptX codec for higher-quality audio streaming. Your source device must also support aptX for this to work.

cVc Technology

Clear Voice Capture (cVc) technology is used for noise cancelling and enhancing selective listening during calls.

Dual Pairing

Connect Rockerz Apex to two devices at once. Pair to the first device, turn off both the earphones and that device’s Bluetooth, pair to the second device, then re-enable the first device’s Bluetooth to have both stay connected.

Multifunction Button (MFB) & Touch Sensor Controls

Action	Function
Press & hold MFB (3 sec)	Power ON
Press & hold MFB (5 sec)	Power OFF
Hold MFB + long touch bottom of touch sensor (5 sec)	Factory Reset / Clear paired devices
Short press MFB once	Play/Pause, Answer/End call
Double press MFB (during call ring)	Reject call
Triple press MFB	Activate Voice Assistant
Long press MFB (3 sec)	Toggle BEAST™ Mode
Swipe touch sensor from ‘-‘ up to top	Volume Up
Swipe touch sensor from ‘+’ down to bottom	Volume Down
Double tap bottom ‘-‘ of touch sensor	Previous Track
Double tap top ‘+’ of touch sensor	Next Track
Double tap touch ring	Toggle Spatial Bionic Sound / boAt Signature Sound

Pairing & Connectivity

Initial Pairing

Press & hold the MFB to switch the earphones on
You’ll see a prompt as well as rapid blinking of the LED indicator
Turn on Bluetooth on your device and search for ‘Rockerz Apex’
Select the device from the list; enter passcode 0000 (or 1234 if prompted during reconnection troubleshooting)
Once paired, the earphones are ready to play music, and will auto-reconnect when back in range with Bluetooth on

LED Indicator Guide

Pairing mode: Red and blue LEDs blink alternately (rapid blinking)
Charging: Red LED turns ON
Fully charged: Red LED turns OFF

Charging & Battery

How to Charge

Use the provided USB Type-C cable to charge the earphones and connect to a computer or wall adapter
Use a 5V/2A charger for correct voltage
Full charge takes about 50 minutes
Red LED turns ON while charging and turns OFF once fully charged

Troubleshooting Guide

Bluetooth Connectivity Issues

Earphones not connecting via Bluetooth

Ensure Bluetooth is ON and the earphones are in pairing mode (alternating red/blue LED flashes)
Confirm the device is within 10m range with no obstructions
If prompted for a passcode, enter 0000 or 1234
Clear the pairing list with a factory reset
Check for software issues on your phone; try forgetting the device or updating mobile software

One side not working or disconnecting frequently

Clear “Rockerz Apex” from your device’s pairing history first
Long press the MFB and long touch the bottom of the touch sensor simultaneously for 5 seconds to clear paired device history

Dual pairing not working

Pair to the first phone as per usual procedure, then switch off both the earphones and the first phone’s Bluetooth
Switch the earphones back on and pair to the second phone
Switch the first phone’s Bluetooth back on – the earphones should reconnect to both
Try dual pairing with other devices to isolate the issue

Charging Issues

Earphones not charging

Test the charging cable with another device
Use only a 5V/2A wall adapter
Check for dirt or debris in the charging port and clean with a cotton swab
Verify the battery wasn’t tampered with or exposed to electrical damage

Sound Issues

Sound is distorted, low volume, low bass, or muffled

Set your phone’s equalizer to normal/default/none/0 (see phone-specific EQ paths below)
Perform a factory reset
Clean ear wax buildup and gently blow dry from a distance if water droplets are present (avoid overheating)

Volume changes automatically

Check equalizer settings on the connected device
Test with a different media player or device to isolate the issue

Power & Control Issues

Device doesn’t power on

Confirm the device has been fully charged (solid red LED turns off when complete)
Test the charging wire with another device
Verify the charger voltage is 5V/2A
Clean the charging port if clogged with dirt
Check for mishandling, broken wires, or extreme heat exposure

Built-in controls not working

Unpair/Forget the device and pair again
Test controls when connected to a different device
Verify the media player supports Bluetooth controls
Check for physical damage or hazard exposure

Voice assistant doesn’t wake up

Check that Google Assistant or Siri is enabled on your paired device
Triple press the MFB to activate; this may be restricted by default on some devices

Microphone Issues

Voice is muffled during calls / microphone not working

Restart the device
Perform a factory reset
Ensure no objects obstruct the connection; move closer to your device
Check the microphone hole for dirt or earwax and clean gently

Phone-Specific EQ Settings

Phone Brand	EQ Path
Vivo	i Music > Audio effect > Deep space sound effects > Equalizer
Xiaomi	Settings > Sound & vibration > Sound effects > Graphic equalizer
Samsung	Settings > Sound quality and effects > Equalizer
Realme	Settings > Sound > Equalizer (varies by UI version)
Oppo	Settings > Sound & vibration > Equalizer
Apple	Settings > Music > EQ
Motorola	Settings > Sound > Audio effects
Poco	Settings > Sound & Vibration > Graphic Equalizer
OnePlus	Settings > Sound Quality & Effects > Audio Tuner

Frequently Asked Questions

How long is the battery life?

Rockerz Apex offers up to 30 hours of playtime, with a full charge taking about 50 minutes.

Does it have a dedicated microphone?

Yes, Rockerz Apex has a dedicated mic perfect for calls and recording.

Can I connect two devices at the same time?

Yes, Rockerz Apex supports dual pairing, letting you connect two devices simultaneously.

What is Spatial Bionic Sound?

Spatial Bionic Sound, powered by DIRAC, is on by default for an immersive listening experience. Double tap the touch ring to switch to boAt Signature Sound instead (a long tone confirms Spatial Sound is on; a short tone confirms it’s off).

How do I activate BEAST™ Mode?

Long press the MFB for 3 seconds to activate or deactivate BEAST™ Mode for low latency.

Does it support the aptX codec?

Yes, Rockerz Apex supports aptX. For this codec to work, your media device must also support aptX.

Does it have cVc technology?

Yes, Rockerz Apex supports Clear Voice Capture (cVc) technology, used for noise cancelling and enhancing selective listening.

Is it good for gaming?

Rockerz Apex features low latency for entertainment needs. It’s okay for casual gaming, but not intended for professional gaming – performance also depends on the connected media device.

Can I swim with the Rockerz Apex?

Rockerz Apex in-ear earphones have IPX4 water and dust resistance, making them well-suited for sports and adventures, though they’re not designed for submersion or swimming.